Waterproofing Products
SP Liquid Membrane®
Elastomeric Hydrocarb on Aliphatic Polyurethane
SP LIQUID MEMBRANE is a tough, one-part elastomeric hydrocarb on aliphatic polyurethane coating that is loaded with a ceramic pigment for strength. Upon curing, SP LIQUID MEMBRANE provides a protective coating film of superior adhesion and flexibility, and is resistant to abrasion and impact. SP LIQUID MEMBRANE can be used as a primer, as a one-coating system or as a topcoat to seal SUPERTHERM ® from ponding water. SP LIQUID MEMBRANE can be applied over pressure-washed substrate of TPO, EPDM, PVC, wood, concrete or metal.
Typical Uses
-
As a protective coating on metal, concrete, wood, etc. to add water resistance and longevity.
-
As a one-coat system on new or existing roofs, and other commercial/industrial surfaces with minimal surface preparation.
-
As a moisture-protective membrane to stop moisture penetration, contaminants, mold and mildew.
-
As a top coat in a thin film over HPC and HSC Coating to protect from weathering and water, helping to guard from abuse during normal operations.
Super Base® (HS) -
Application Instructions
Acrylic Caulking / Membrane -
SUPERBASE (HS) ® is designed from the best-known high performance elastomeric specially formulated acrylic in the market, known for adhesion, ability to pond water, weatherability, UV resistance, flexibility and toughness. SUPERBASE (HS) ® was blended to work cohesively with our MULTI MESH MEMBRANE and SUPERTHERM ® \ SUNSHIELD ® , together or separately, to form a complete seal on any roofing or wall structure. SUPERBASE (HS) ® is also applied as a base coat over MASTIC SEALING TAPE on joints, seams, around A\C units, vents or any areas where leaks would most likely occur. Longevity of service was the concern and the determination for quality was built into this base \ primer coating. It is a water based high-performance acrylic that is easily applied without environmental concerns and compliments the quality of the SUPERTHERM ® \ SUNSHIELD ® base \ top coat.
-
SUPERBASE (HS) ® was designed to be applied to roofing structures to seal cracks. Seal over tar with SUPERBASE (HS) ® before applying SUPERTHERM ®, apply SUPERBASE (HS) ® over asphalt shingles or concrete or wood to seal before applying SUPERTHERM ® \ SUNSHIELD ® . It gives the correct base \ primer coat to seal over dry substrates to be absorbed into the surface allowing SUPERTHERM ® \ SUNSHIELD ® to set up properly. This affords the full effect of its ceramic mixture.
-
SUPERBASE (HS) ® is designed to apply to all roofing whether flat or inclined, in new construction or to retrofit wood, concrete, tar, sheeting, polyfoam, or sheetrock. This gives outstanding adhesion, scaling protection, flexibility and acts as a base \ primer coat for encapsulating the surface prior to applying SUPERTHERM ® \ SUNSHIELD ® .
Uses
To cover over seams that are no more than 1/32" opened to seal from water penetration and secure the seam. If seams are standing open more than 1/32", then using the fabric membrane is recommended in combination with the SUPERBASE (HS) ® to secure the seams.
Limited Warranty
Unless Superior Products provides a written warranty of fitness for a particular use, Superior Product's sole warranty is that the product, as supplied, will meet the current sales specifications and is specific only to return of product found to be defective upon opening of the container within one year. Customer's exclusive remedy and Superior's sole liability for breach of warranty is limited to refund of the purchase price or replacement of any product shown to be other than as warranted and Superior Products expressly disclaims any liability for incidental or consequential damages.
